Falcon II Outdoor series printers – Maintenance Manual
281
AP-74065, Rev. 1.0, 21/11/03
(5) Check the up
and down
operation of the
solenoid via
“Life/Cutter” of the
self-diagnostic
function.
a) The solenoid
moves up and
down : Check the
cutter’s down
position relative to
the cutter groove.
b) It does not
move up and
down.
OK :
The cutter’s
service life is
reached or it is
damaged.
Replace the cutter.
NG :
Adjust the position
of the cutter
holder.
• The connectors
may have poor
contacts.
Check the
connections of the
following
connectors :
CR board : J235
CR board : J201 –
J216
Mainboard : J137
– J152
→
Please refer to
the User’s Guide
→
Cutter
adjustment
→
Replacing the
CR board
assembly.
→
Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
(6) Open CR
cable, faulty
solenoid assembly,
faulty board
assembly, etc.,
may be the cause.
•Replace the CR
tape power cables.
• Replace the
solenoid assembly
• Replace the CR
board assembly
• Replace the
Mainboard
assembly.
→
Replacing the
steel bearer, tube
guide, CR tape
power cable and
ink tube.
→
Replacing the
cutter holder,
cutter spring,
cutter cap,
solenoid
assembly and
solenoid spring
→
Replacing the
CR board
assembly
→
Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
4
End of Roll
Displayed when the
end of the roll paper
is detected during
the use of roll paper.
This is released
when the lever has
(1) Check if the
message is still
displayed after
turning the power
off and then back
on again.
If the message is
displayed : go to
step (2)
