Falcon II Outdoor series printers – Maintenance Manual
280
AP-74065, Rev. 1.0, 21/11/03
(6) The CR board
assembly may be
damaged.
• Replace the CR
board assembly.
→
Replacing the
CR board
assembly.
(7) The Mainboard
assembly may be
damaged.
• Replace the
Mainboard
assembly.
→
Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
2
Paper Slant
The paper is fed
askew.
(1) Reset the
paper and check if
the condition
recurs.
• If this is caused
by incorrect paper
setup, explain the
correct paper
setup procedure.
-
(1) Check the
cutter grooves for
accumulated paper
dust and slip.
• Remove the
accumulated paper
dust along the
direction of the
grooves.
→
Please refer to
the User’s Guide.
(2) has the cutter
cap securely been
installed?
• Reset the cutter
cap securely
→
Please refer to
the User’s Guide.
(3) Check the
cutter’s up and
down sliding
operation.
• If it does not rise
: Go to step (4)
• If it rises : Go to
step (5)
3 Paper
Cut
Error
Even though cutting
operation was
performed, the
paper was not
completely cut and
removed.
(4) Check if the
cutter drops to the
bottom end under
its own weight
when the cutter
has been installed
without the cutter
spring.
•If it drops : The
cutter spring may
have a problem.
Replace the cutter
spring while
referring to the
unfolded view.
• If it does not drop
: The cutter may
have a problem.
Replace the cutter.
If the cutter does
not drop after
replaced, replace
the cutter holder.
→
Replacing the
cutter holder,
cutter spring,
cutter cap,
solenoid
assembly and
solenoid spring.
