Falcon II Outdoor series printers – Maintenance Manual
133
AP-74065, Rev. 1.0, 21/11/03
4.10. REPLACING THE CARTRIDGE AREA
4.10.1. Replacing the I/H (ink holder) assembly
There are 8 I/H assembly 's installed in this printer. Following procedure is for the removal of 1 I/H assembly.
Notes :
¾
Remove following covers before replacing the parts in the I/H assembly.
I/H cover: refer to "Removing the I/H cover"
Side cover R: refer to "Removing side cover R"
Panel unit assembly: refer to "Removing the panel unit assembly"
(1) Removing the I/H assembly
Step 1 :
Perform the ink discharge operation to discharge the ink from the inside of all ink paths.
Notes :
¾
For ink draining procedure, refer to "Head wash menu".
Step 2 :
Remove the following connectors from the JUNCTION board assembly.
¾
Ink sensor assembly connectors (8)
¾
SC cable assembly connectors (8)
Notes :
¾
For more details of the JUNCTION board assembly connector, refer to "Table
Connectors connected to the JUNCTION board assembly" in "Replacing the
JUNCTION board assembly".
Step 3 :
Remove the sensor assembly harnesses removed in step 2 from their clamps.
Step 4 :
Pull the harnesses out of the grommets on the board base fixing plate.
Step 5 :
Follow the step 1 to 3 in "Replacing the power source board assembly" to remove the Mainboard base.
