Falcon II Outdoor series printers – Maintenance Manual
125
AP-74065, Rev. 1.0, 21/11/03
Notes :
¾
Secure the maintenance assembly so that it abuts against the rear right portion.
¾
If the cap tube has not been cut, cut it to the length below, measured from the end
of the tube: Numbers in brackets ( ) are the cap numbers from left to right as viewed
from the front of the main body. For 50, 64 inch model: (1) 50mm, (2) 0mm, (3)
40mm, (4) 0mm For 87 inch model: (1) 90mm, (2) 50mm, (3) 40mm, (4) 70mm,
(5) 0mm, (6) 30mm, (7) 30mm, (8) 0mm
¾
The connection sequence for the tubes is as follows: Numbers in brackets ( ) are
the cap numbers from left to right as viewed from the front of the main body.
o
50 or 64 inch model: Cap (a) and Pump (1), Cap (b) and Pump (3), Cap (c) and
Pump (2), Cap (d) and Pump (4)
o
87 inch model 2 heater: Cap (a) and Pump (1), Cap (b) and Pump (3), Cap (c) and
Pump (4), Cap (d) and Pump (2), Cap (e) and Pump (7), Cap (f) and Pump (5), Cap
(g) and Pump (6), Cap (h) and Pump (8)
o
87 inch model 4 heater: Cap (a) and Pump (1), Cap (b) and Pump (3), Cap (c) and
Pump (4), Cap (d) and Pump (2), Cap (e) and Pump (5), Cap (f) and Pump (7), Cap
(g) and Pump (8), Cap (h) and Pump (6)
50” or 64” Falcon II Outdoor 2 heater
87” Falcon II Outdoor 2 heater
50” or 64” Falcon II Outdoor 4 heater
87” Falcon II Outdoor 4 heater
