Falcon II Outdoor series printers – Maintenance Manual
174
AP-74065, Rev. 1.0, 21/11/03
5.5.6. CW Adjustment Menu
In this menu, you can adjust the gap (CR moving direction) between two heads.
To adjust the gap between two heads, you should first print out a Uni-D printing and identify the difference between the
selected two heads.
Then, you enter the difference for the relevant parameter.
To perform a Uni-directional Adjustment, please follow the steps mentioned below.
Step 1 :
Go to [Adjust : Uni-D].
Step 2 :
Print out the adjustment pattern.
1 = Adjust this dash line so it becomes a straight line.
Step 3 :
Adjust each Head to become a straight line. (The 1
st
Head is the reference Head.)
Caution :
Due to the tolerance of parts and assembly precision, all lines might not be straight. If
this is the case, adjust the uni-directional difference amount equally.
