Motortech DetCon series, Руководство по эксплуатации

Страница: 79 / 90

8 DenEdit Settings
Rev. 02/2019 79
Diagnosis
The binary and analog outputs can be tested via the settings in this area. Activate the checkbox
to activate the respective output. You can simulate an analog output signal via the field
Reg.
Output in order to test the connection to an ignition controller, for example. The checkbox
Diagnostics must be deactivated again for operations.
8.8.2 Tab: Knocking Params
Engine type
In this area, you can select the engine settings suited to your application. In general, these
values are contained in the parameter file and must not be manually adjusted:
– In-line, V-type, Irregular
Select the engine type. Select In-line for an in-line engine and V-type for a V engine. The
setting Irregular allows you to define an individual firing sequence in the tab Firing
sequence .
– 2-, 4-stroke
Select the operating mode of the engine: 2-stroke or 4-stroke .
– V-angle
Enter the firing angle for V engines.
– Cylinder count
Enter the number of cylinders.
Detonation window parameters
In this area, the values are entered for the frequency range in which knocking is likely to occur.
These settings are either specified by the parameter file or, if required, determined by
MOTORTECH service personnel during calibration. In order to ensure the correct functioning of
the detonation controller, these values may not be altered.
– Deton. window delay
Delay of the first cylinder ignition measured by the interval following the ignition pulse. The
basis is the rising edge of the synchronization pulse.
– Deton. window width
Window of time for knock analysis.
– Knock filter frequency
Characteristic knocking frequency.