Motortech DetCon series, Руководство по эксплуатации

Страница: 68 / 90

68 Rev. 02/2019
You can configure the DetCon detonation controller and display the current knocking values of
the engine using the DenEdit software application. The device can be operated via the software
in three different basic modes:
– Measurement mode
– Interface diagnostics mode
– Knock detection mode
Measurement Mode
The measurement mode is used for engine calibration. Calibration is only required for engine
types for which a parameter file has not yet been created and is executed by MOTORTECH service
personnel.
Interface Diagnostics Mode
The interface diagnostics mode can be used to test the output signals at the binary and analog
inputs. The values set in the area
Diagnose in the tab Mode are transmitted to the outputs of the
device. Knocking analysis is not carried out.
Knock Detection Mode
Knock detection mode is the operation mode of the detonation controller. After synchronization,
the signals of the knocking sensors are analyzed and output signals are generated accordingly
for the binary and analog outputs. The condition of the outputs are indicated via LEDs and the
signals of the detonation sensors are displayed in the tabs for process monitoring. Error
monitoring is also performed, for example, for registering faulty detonation sensor signals.
8.1 DenEdit System Requirements
For the installation of DenEdit, the following minimum requirements must be fulfilled:
– Operating system: Microsoft Windows XP, Windows 7, Windows 8 and Windows 10
– Approx. 10 MB free disc space
– Interface compatible to USB 1.1, required minimum speed 90 kBit/s (44.1 kHz, 16 Bit),
connector type B
8 DenEdit Settings