Motortech DetCon series, Руководство по эксплуатации

Страница: 73 / 90

8 DenEdit Settings
Rev. 02/2019 73
8.4 Menu Bar and Toolbar
The following functions are available to you via the symbols on the toolbar and the entries in the
menu bar:
Symbol Menu Function
Connection -> Connect
USB
Establishes connection between DetCon and the PC.
Connection -> Disconnect
Disconnects DetCon from the PC.
Connection -> Open
parameters
Opens a file dialog in which you can select a parameter
file.
Connection -> Save as
Saves the set values as a new parameter file.
Connection -> Setup
Opens a dialog in which the communication port (COM)
settings can be made.
Connection -> Exit
Exits the program.
Controller -> Enter
password
Opens a window for entering a password. The
password is required in order to change parameters.
The default setting of the password is
0 (zero).
Controller -> Deactivate
password
If parameters secured by a password have been
changed, this function can be used to secure password
protection for access to the software.
Controller -> Change
password
Opens a window in which you can change the
password.
Controller -> Get
encrypted password
If you forget your password, you can receive an
encrypted password with this function. Please contact
MOTORTECH service personnel with this password and
the serial number of the device.
Controller -> Two sensors
mode
Switches to two sensors mode in order to operate the
DetCon2.
Controller -> Device SW
ver. ...
Select from the entries displayed the entry
corresponding to the software version of your device
(firmware). The software version used is indicated on
the nameplate on the device.
Controller -> Reset peak
value
Resets the stored peak value of the knocking intensity
displayed on the tab
Knocking history .
Help -> About
Opens version and contact information.