Motortech DetCon series, Руководство по эксплуатации

Страница: 70 / 90

8 DenEdit Settings
70 Rev. 02/2019
1. Set the name for your device by changing the entry in the field corresponding to your device
type.
2. Accept the input with OK .
▸ The name is now displayed in the status bar of the software.
Assign the Communication Port
In order to establish communication between the PC and the device, you must first set the
communication port to be assigned to the USB interface.
Proceed as follows:
1. Open the device manager of your PC via the control panel.
2. You can see which COM port was assigned to the USB interface under the entry Ports .
3. Note that only COM ports 1-16 can be set in DenEdit. Change the port assignment if
necessary.
4. Open DenEdit.
5. Open the window Setup via the menu entry Connection -> Setup .
6. In the field USB serial converter / COM port , enter the number of the COM port set on the PC.
7. If you activate the checkbox Open connection after startup , the software automatically
connects with the connected device after startup if the USB connection is active.
8. Accept the input with OK .
Establish a Connection to the Device and Load the Parameter File
The parameter file of the respective engine must be loaded to the device prior to start-up. The
CD-ROM supplied with the device contains files for engines which have already been calibrated.
If there is no parameter file for the desired engine, a calibration must be performed. This can
only be carried out by MOTORTECH service personnel.
Calibration for diesel and pilot injection engines
For diesel and pilot injection engines, calibration must be performed by
MOTORTECH service personnel.