Motortech DetCon series, Руководство по эксплуатации

Страница: 77 / 90

8 DenEdit Settings
Rev. 02/2019 77
8.7.2 Tab: Knocking History
The knocking history continuously shows the curve of the varying knocking intensities
registered over the last minute. The color background indicates the set limits:
– Ignition reduction limit : the border between black and yellow
– Immediate stop limit : the border between yellow and red
The maximum knocking value is shown as a dotted line. The legend on the right indicates which
color corresponds to which cylinder. The white curve (
Reg . in the legend) maps the signal of the
analog outputs.
8.8 Tabs for the Process Parameters
The basic settings for the required engine and the device used are set when the parameter file is
loaded. You can inspect and modify these settings as needed in the tabs for the process
parameters.
The following tabs are available for the process settings:
– Mode
In this tab, you can enter general display and diagnostics settings. This is also where you
can start sound recordings of knocking signals.
– Knocking params
This tab shows both engine settings and the parameters for knocking analysis. These
settings are either specified by the parameter file or, if required, determined by MOTORTECH
service personnel during calibration. In order to ensure the correct functioning of the
detonation controller, these values may not be altered.
– Input gains
In this tab, you can amplify or attenuate signals for individual channels in order to
compensate for signals similar to knocking signals.
– Firing sequence
In this tab, you can specify individual firing sequences for special engine types.
– Output options
In this tab, you can enter settings for knocking detection limits and other analysis values.
– CAN params
In this tab, you can enter settings for communication via the CAN bus.