Motortech DetCon series, Руководство по эксплуатации

Страница: 11 / 90

2 Safety Instructions
Rev. 02/2019 11
2.3 Special Safety Instructions for the Device
High voltage! Danger to life!
There is danger to life while the engine is operating due to high voltage. The
following safety instructions must therefore be observed when the engine is
running:
– Do not touch the ignition sensor unit (ISU)
– Do not remove the ignition sensor unit (ISU)
– Do not loosen the wiring
Risk of destruction due to electrostatic discharge!
The DetCon detonation controller may only be installed in a switch cabinet
by qualified personnel trained in the handling of ESD-endangered
components, observing the ESD regulations. The ESD standard IEC 61340-5-
1:2016 must be observed during installation. No warranty is given for
damage due to electrostatic discharge.
Operational safety
The DetCon
d etonation c ontroller
requires high voltage ignition wires
with integrated 5 k
Ω
resistance, as otherwise interference in the
detonation
sensor signals may be caused. Any other ignition wires must be replaced.
Risk of damage
The detonation sensor attachment screws must not be tightened too firmly,
as otherwise the sensors will be damaged and no longer function
properly.Observe the following information for sensor mounting:
– Torque: 20 Nm ± 5 Nm (14.8 ± 3.7 lb-ft) for mounting screws:
–
made of cast iron: M8 x 25 mm (0.98"), Strength: 8.8
–
made of aluminium: M8 x 30 mm (1.18"), strength: 8.8
– Torque: 15 Nm ± 5 Nm (11 lb-ft ±2.2 lb-ft) for M6 fixing screws, strength
10.9 with sleeve