Mitsubishi Fuso CANTER FE85DE6SLGP, Руководство по ремонту

Страница: 310 / 336

15
15-31
Disassembly sequence
CAUTION
• Loosen the marked bolt first to prevent undue forces from being applied to the exhaust pipe.
Assembly sequence
Follow the disassembly sequence in reverse.
CAUTION
• Tighten the marked bolt last to prevent undue forces from being applied to the exhaust pipe.
Tightening torque (Unit: N·m {kgf·m})
Installation procedure
Installation: Front pipe
• Install the front pipe so that the amounts of offset in both vertical
and horizontal directions between the pipes in front of and be-
hind the bellows are smaller than the dimension indicated in the
illustration.
CAUTION
• The bellows on the front pipe have the purpose of reducing
the level of noise from the vehicle. It is not intended for
compensating for misalignment that may result from im-
proper installation of the front pipe. Install the front pipe
properly to avoid excessive tension or other stress on the
bellows.
Mark Parts to be tightened Tightening torque Remarks
Nut (front pipe mounting) 45 to 60 {4.6 to 6.1} –
Bolt (exhaust shutter unit mounting) 27 to 29 {2.8 to 3.0} –
1 Brace bracket
2 Gasket
3 Front pipe
4 Exhaust shutter
(See later section.)
5 Front pipe
*
a : Exhaust manifold
: Non-reusable parts
EXHAUST PIPE