Mitsubishi Fuso CANTER FE85DE6SLGP, Руководство по ремонту

Страница: 128 / 336

11-90
[Installation]
•
To install the bushings, use the rod fitted with an adapter corre-
sponding to the size of each bushing. Each bushing has an iden-
tification mark. These identification marks are used to
distinguish between the No. 1, No. 2 and No. 3 bushings. If the
identification mark is not clear, measure the outside diameter of
the bushing and use the measurement as a means of identifica-
tion.
Unit: mm
• Align the oil hole in the No. 3 bushing with the oil hole in the up-
per crankcase.
• Force the No. 3 bushing into the upper crankcase as deep as
the mark in the illustration by tapping on the rod from the rear
of the engine.
Bushing Adapter Guide piece
Identi-
fica-
tion
mark
Out-
side di-
ameter
Identi-
fica-
tion
mark
A B C
Iden-
tifica-
tion
mark
D
No. 1
Left “LH1”
φ
55.25
“5”
φ
55.25
φ
51.5
26.5 “5”
φ
55.25
Right “1”
φ
55.25
“6”
21.5
“6”
No. 2 “2”
φ
55 “7”
φ
55
φ
51 “7”
φ
55
No. 3 “3”
φ
54.75
“8”
φ
54.75
φ
50.5
“8”
φ
54.75
BALANCE SHAFT BUSHINGS