Mitsubishi Fuso CANTER FE85DE6SLGP, Руководство по ремонту

Страница: 184 / 336

13-30
Installation procedure
Installation: Supply pump
• Remove the rocker cover.
• Bring the No. 1 cylinder piston to the top dead center (TDC) on
the compression stroke by the following procedure:
• Hook on a groove in the fan pulley.
• Turn the fan pulley in the illustrated direction so that the pointer
is aligned with the “
I , IV ” or “1” to “4” mark on the inscribed scale
on the flywheel.
• This will place either the No. 1 or No. 4 cylinder piston at TDC on
the compression stroke. The cylinder in which the rocker arms
for both the intake and exhaust valves can be pushed down by
hand by the valve clearance amounts has its piston at TDC. Ro-
tate the engine by one full turn to switch the TDCs of the No. 1
and No. 4 cylinder pistons.
• Align the match mark “P” on the supply pump idler gear with that
of the supply pump gear.
• Align the notch on the flange plate with the notch on the supply
pump gear.
• Check that the notch on the flange plate and the notch on the
supply pump gear are correctly aligned, and then push the sup-
ply pump.
Installation: Fuel pipe
• Ensure that the pipe and mounting surfaces of the connector are
flat and free from damage.
• Bring the pipe into intimate contact with mounting surfaces of the
connector evenly, and temporarily tighten it without applying an
excessive force.
• Tighten it to the specified torque after temporary tightening.
SUPPLY PUMP