Mitsubishi Fuso CANTER FE85DE6SLGP, Руководство по ремонту

Страница: 300 / 336

15
15-21
Service standards (Unit: mm)
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Work before removal
Alignment mark
• Put alignment marks on the pin and lever.
CAUTION
• Be sure to provide alignment marks on the lever and pin to
ensure installation of the pins in right places when reused.
Pins in wrong position would change boost pressure to re-
sult in a malfunctioning or damaged engine.
Work after disassembly
Cleaning
• Before cleaning, visually check the disassembled parts for
scorches, abrasion and other marks that may be difficult to see
after cleaning. Replace any part that appears defective.
• Immerse the disassembled parts in a non-flammable solvent (a
5 to 10 aqueous solution of Oil Clean from New Hope Co., Ltd.).
Take out the parts and blow them dry with compressed air. Re-
move any hard deposits with a stiff brush or plastic scraper.
CAUTION
• Do not immerse the cartridge assembly in the solvent. Do-
ing so will cause the O-ring inside the cartridge assembly to
sell up, which may adversely affect turbocharger operation.
• Again, immerse the parts in the solvent.
• Blow them dry using compressed air.
Location Maintenance item Standard value Limit Remedy
2 Pin outer diameter 8 7.5 Replace
3 Lever inner diameter

8

8.5 Replace
4 Joint inner diameter

8

8.5 Replace
6 Actuator shaft stroke 18.5 to 21 18.4 Replace
11 Play in shaft axis direction of turbine assembly 0.39 to 0.67 – Replace
Mark Parts to be tightened Tightening torque Remarks
Bolt (bracket mounting) 21.6 to 23.5 {2.2 to 2.4} –
Lock nut 4.9 to 9.8 {0.5 to 1.0} –
Mark Points of application Specified lubricant and/or sealant Quantity
Thread area of nuts
Seizure preventive compound
(FEL-PRO CA-5)
As required