Mitsubishi Fuso CANTER FE85DE6SLGP, Руководство по ремонту

Страница: 224 / 336

13E
13E-37
P0563: Power Supply Voltage (High) (warning lamp flashes: 33)
P0600: CAN Communication (warning lamp flashes: 64, 73)
P0607: ECU System (warning lamp flashes: 33)
P060B: A/D Converter (warning lamp flashes: 33, 63)
Generation condition Battery voltage is too high.
Recoverability
System recovers if any valid signal is input when starter switch is turned from
OFF to ON (the warning lamp does not go out unless 3 consecutive valid signals
are input).
Control effected by electronic control unit Control of engine is stopped.
Possible causes • Malfunction of electronic control unit (Replacement of electronic control unit)
Generation condition
Abnormal CAN bus communications between engine electronic control unit and
malfunction vehicle control unit or between engine electronic control unit and any
of electronic drive units (exhaust gas recirculation, intake throttle and turbocharg-
er units).
Recoverability
System recovers if any valid signal is input when starter switch is turned from
OFF to ON (the warning lamp does not go out unless 3 consecutive valid signals
are input).
Control effected by electronic control unit
• Injection quantity is limited.
• Exhaust gas recirculation control is stopped.
• Throttle control is stopped.
• Turbocharger control is stopped.
Possible causes
• Open-circuit or short-circuit of harness between engine electronic control unit
and each of electronic drive units (exhaust gas recirculation, throttle and tur-
bocharger)
• Malfunction of each connector
• Malfunction of engine electronic control unit
• Malfunction of each of electronic drive units (exhaust gas recirculation, throttle
and turbocharger)
Generation condition
• System is overloaded.
• Data processing time of engine electronic control unit has exceeded time-out
period.
Recoverability
System recovers if any valid signal is input when starter switch is turned from
OFF to ON (the warning lamp does not go out unless 3 consecutive valid signals
are input).
Control effected by electronic control unit Engine is stopped.
Possible causes
• Malfunction of engine electronic control unit (Replacement of engine electron-
ic control unit)
Generation condition
Voltage after conversion inside engine electronic control unit is higher than spec-
ification (5 V).
Recoverability
System recovers if any valid signal is input when starter switch is turned from
OFF to ON (the warning lamp does not go out unless 3 consecutive valid signals
are input).
Control effected by electronic control unit
• Engine is stopped.
• Engine speed is limited.
• Turbocharger target opening value is replaced by a backup value.
• Exhaust gas recirculation control is stopped.
• Throttle control is stopped.
Possible causes
• Malfunction of engine electronic control unit (Replacement of engine electron-
ic control unit)