Micromeritics AccuPyc 2 1340, Руководство оператора

Страница: 81 / 158

AccuPyc II 1340 Reviewing Data
June 2013 4-9
Using a Web Browser
Data results for the last five analyses are saved in the control module for each attached unit.
These results can be viewed by accessing a web browser.
To use this feature, you must be connected to a network via an ethernet cable and have a key-
board attached to a USB port.
1. Make a note of the IP address:
a. Press Alt + 2 to access Set Up .
b. Press CHOICE until Communications is displayed, then press ENTER . The following
prompt is displayed:
The fourth line may show Specify , depending on the manner in which the IP address
was assigned (refer to Communications , page 3-18 for additional information on this
prompt).
c. Press
ENTER
to view the assigned address:
If the address was specified, the third line of the display shows IP Address? and the
fourth line shows the entered address. This line is editable since it is specified and not
assigned automatically. An assigned address cannot be edited.
d. Press
Alt + CLEAR
to return to the Reload prompt.
2. Access your web browser.
3. Enter your IP address in the Address field of the web browser.
This will consist of 12 numbers in the following format: nnn.nnn.nnn.nnn.
These steps assume an IP address has already been assigned. If an address has not
been assigned, refer to
Communications , page 3-18
for information on obtaining one.
Unit[n] SN1234 10 cm3
Communications
IP Address?
DHCP
Unit[n] SN1234 10 cm3
Communications
Assigned Address:
(assigned address)