Micromeritics AccuPyc 2 1340, Руководство оператора, Страница: 54 / 158

System Commands AccuPyc II 1340
3-20 Aug 2013
Does not display for DHCP
The Gateway address is used for communicating outside of
your local network. This address is often the same as the
instrument’s IP address with a “1” after the last dot instead
of the last three characters. For example, nnn.nnn.nnn.1
Contact your IT Department if you have questions.
Enter the gateway address and press
ENTER
.
When connected to a network via the ethernet connection
on the rear panel of the analyzer, you can have analysis (or
calibration) results e-mailed automatically at their
completion. This prompt enables you to enter the e-mail
address to which results are to be sent.
If you are not using DHCP and the e-mail address is outside
the local network, be sure to specify a gateway address (see
previous prompt).
To use this option, you should have a keyboard connected
to one of the USB connectors.
Enter the e-mail address and press
ENTER
.
This prompt enables you to enter the numerical address of
the SMTP server (the computer that is going to deliver the
results). If this address is unknown, contact your IT
Department.
Your IT Department may need to configure the server to
accept e-mail from the AccuPyc. For proper configuration,
the following information may be required:
• IP address for the AccuPyc
• Sender line:
Micromeritics-1340
Press ENTER .
Unit[n] SN1234 10 cm3
Communications
Gateway:
(user-entered)
Unit[n] SN1234 10 cm3
Communications
E-mail Address:
Unit[n] SN1234 10 cm3
Communications
E-mail Server: