METRObility Optical Systems R821-1S, Инструкция по установке и эксплуатации

Страница: 73 / 127

71
CLI Commands
set ratelimit
Description : Set the rate limit on the specified port or activate/cancel
rate limiting.
Syntax : set ratelimit <port number> [rate <128 | 256 | 512 | 1000 |
2000 | 4000 | 8000 | 100000>] [state <disable | enable>]
Parameters : port number – the actual port number.
rate – specify the ingress (inbound) traffic rate limit in Kbps
on the selected port to one of the following rates:
128, 256, 1000, 2000, 4000, 8000, or 100000.
Because the R821 is a two-port device, changing the
ingress rate automatically changes the egress
(outbound) rate on the opposite port.
state – activate or cancel rate limiting.
disable – cancel rate limiting and allow traffic to flow
at full line rate.
enable – activate rate limiting. The maximum rate is
set to the value specified by the rate option.
Example :
Console> set ratelimit 1 rate 8000 state enable
Console>
set
snmpcommunity
Description : Set SNMP community and its corresponding access profile.
Syntax : set snmpcommunity <community name> profile <ro |rw |
admin>
Parameters : community name – a case-sensitive ASCII string (up to 50
characters in length) denoting the receive profile on
the trap destination host. If unspecified, the default
value is NULL.
profile – specifies the access profile for a community user.
ro – read-only access to non-privileged objects.
rw – read-write access to non-privileged objects.
admin – full read-write access to all objects.
Example : Console> set snmpcommunity public profile ro
Console>
set snmpuser
Description : Set the name along with the authentication and privacy param-
eters for SNMPv3 access.
Syntax : set snmpuser <user name> auth <none | md5> [authpwd
<auth password>] priv <none | des> [privpwd <priv
password>] group <ro | rw | admin>
Parameters : user name – a case-sensitive ASCII string (up to 50
characters in length) denoting the user name that
has SNMPv3 access to the device.
auth – identifies the authentication protocol.
none – No authentication is performed.
md5 – MD5 protocol is used to encrypt the authenti-
cation process. This option requires an authenti-
cation password.