METRObility Optical Systems R821-1S, Инструкция по установке и эксплуатации

Страница: 71 / 127

69
CLI Commands
set pvid
Description : Set the port VLAN identifier that will be used for tagging
when 802.1Q and Q-in-Q modes are enabled. When the
switch mode is set to Transparent, the PVID is used as the
native VLAN for untagged frames.
Syntax : set pvid <VLAN> [access <port number>]
Parameters : VLAN – VLAN ID in the range 1 to 4094.
access – specifies the access port. If not specified, the
access port will be the port that was last configured
to be the access port. By default, it is Port 1.
Example : Console> set pvid 3
Console>
set qinq
Description : Enable or disable Q-in-Q operation, and optionally bypass
or encapsulate management frames when a management
VLAN is configured.
Syntax : set qinq <enable | disable> [management <bypass| encap-
sulate>]
Parameters : enable – activates Q-in-Q forwarding mode. For more
information, refer to “Q-in-Q Mode” on page 44. Q-in-
Q operation can only be enabled when the switch is
in transparent mode. If the switch is in 802.1Q mode,
an error message will appear.
disable – Q-in-Q mode is disabled. The forwarding mode
will be determined by the ‘set switch’ setting.
management – encapsulate or bypass management
frames when Q-in-Q is enabled. For more infor-
mation, refer to “Management Frames in Q-in-Q
Mode” on page 46.
bypass – if no management VLAN is configured,
allows all management frames to bypass the service
provider tag on the trunk port. That is, management
frames will egress the trunk port untagged. If the
management VLAN is configured, management
frames will egress single-tagged with only the
management VLAN. This is the default setting.
encapsulate – encapsulates all management frames
when there is a management VLAN configured. This
results in double-tagged management frames. If no
management VLAN is configured, management
frames will egress untagged.
Example : Console> set qinq enable
Console>