METRObility Optical Systems R821-1S, Инструкция по установке и эксплуатации

Страница: 69 / 127

67
CLI Commands
remote loopback causes the specified port to send a
loopback request (with the loopback enable flags
cleared) to the remote port.
commands – process or drop incoming requests for
loopback when the specified port receives them.
Example : Console> set oamloopback 2 commands ignore
Console>
set os
Description : Select the operating system image to be used by the
device. To activate the selection, you must reset the device
after changing the OS image.
Syntax : set os <image number>
Parameters : image number – 1 or 2.
Example :
Console> set os 1
OS1 image (1.0.0) will not become active until next reset.
Console>
set pbits
Description : Enable or disable priority bits classification, and set the
policy profile as defined in IEEE 802.1D or IEEE 802.1ad
(Provider Bridge), or use a free form definition.
Syntax : set pbits <enable | disable> [model <802.1D | Provider
Bridge | FF>]
Parameters : enable – enable p-bit classification.
disable – disable p-bit classification. (default)
model – specify the policy to use for p-bit classification.
802.1D prioritizes traffic types in the following order
(highest to lowest): Voice, Controlled Load, Best
Effort, and Background. Provider Bridge prioritizes
traffic types in the following order (highest to lowest):
Network Control, Voice, Critical Applications, and
Best Effort. FF (Free Form) allows you to define the
priority bits. If the model is not specified, the last
configured model will be used; by default it is
Provider Bridge.
Example :
Console> set pbits enable model 802.1D
Console>
set port
Description : Set attributes for a selected port.
Syntax : set port <port number> [autonegotiate <disable | enable>]
[duplex <full | half>] [flowcontrol <disable | enable>]
[management <disable | enable>] [speed <10 |100>] [state
<disable | enable>] [fef <disable | enable>] [llr <disable |
enable>] [llcf <disable | enable>]
Parameters : port number – the actual port number.
autonegotiate – disable or enable auto-negotiation for the
selected port.