METRObility Optical Systems R821-1S, Инструкция по установке и эксплуатации

Страница: 66 / 127

Radiance 10/100 Mbps Services Line Card
64
timeout – maximum number of seconds to allow the port to
remain in loopback mode. The default is 30 seconds. The
range is 30 to 300 seconds.
Example : Console> set loopback 2 enable timeout 60
Console>
set mgmtvlan
Description : Set management VLAN ID. It will be applied to both ports.
The services line card supports one management VLAN
ID. The management VLAN ID number must be different
from the user VLAN ID numbers.
Syntax : set mgmtvlan <vlan id>
Parameters : vlan id – VLAN ID in the range 1 to 4094. To disable
management VLAN, set the ID to 0.
Example :
Console> set mgmtvlan 1070
Console>
set oamcontrol
Description : Set the OAM capabilities for the specified port.
Syntax : set oamcontrol <port number> [admin <enable | disable>]
[mode <active | passive>]
Parameters : port number – the actual port number.
admin – enable or disable administrative OAM mode for
the specified port.
mode – specify active or passive OAM mode for the
selected port. These modes differ in that active mode
provides additional capabilities to initiate monitoring
activities with the remote OAM port, while passive
mode generally waits for the remote OAM port to
initiate actions with it and responds to requests. For
example, an active OAM port can put the remote port
in a loopback state, while a passive OAM port
cannot.
Example : Console> set oamcontrol 2 admin enable mode active
Console>
set
oamerrframe
Description : Set the OAM attributes for number of errored frames
detected for a set time window (100 ms granularity) for the
specified port, and enable or disable notification.
Syntax : set oamerrframe <port number> [window <# of 100ms
counts>] [threshold <frame threshold>] [notify <enable |
disable>]
Parameters : port number – the actual port number.
window – The amount of time (in 100 ms increments) over
which the threshold is defined. The range is 10 to
600, which is equal to 1 to 60 seconds.
threshold – The number of frame errors that must occur for
the Errored Frame Event to be triggered. Example: if