Mercedes-Benz Vito 109 CDI/BlueTEC, Руководство по эксплуатации

Страница: 330 / 396

X Wipe oil dipstick
:
using a lint-free cloth.
X Insert oil dipstick
:
back into the guide tube
as far as it will go and remove it again.
If the level is between MIN mark
=
and MAX
mark
;
, the oil level is adequate.
X
If the oil level has dropped to or below mini-
mum mark
=
, open cap
?
and top up the
engine oil (
Y
page 328).
The difference in quantity between marks
;
and
=
is approximately:
R
2.5 litres for diesel engines with a power
output below 100 kW
R
2 litres for diesel engines with a power out-
put exceeding 100 kW
R
1.5 litres for petrol engines
X
Close the bonnet.
Topping up the engine oil
G
WARNING
If you open the bonnet while the engine is
overheating or while there is a fire in the
engine compartment, you could come into
contact with hot gases or other leaking ser-
vice products. There is a danger of injury.
Allow an overheating engine to cool down
before opening the bonnet. If there is a fire in
the engine compartment, leave the bonnet
closed and notify the fire brigade.
G
WARNING
Certain components in the engine compart-
ment could be very hot, e.g. the engine, the
radiator and parts of the exhaust system.
There is a risk of injury when accessing the
engine compartment.
As far as possible, allow the engine to cool
down and only touch the components descri-
bed in the following.
G
WARNING
If engine oil comes into contact with hot com-
ponents in the engine compartment, it may
ignite. There is a risk of fire and injury.
Make sure that engine oil does not spill out
over the filler neck. Allow the engine to cool
down and thoroughly clean the components
that have come into contact with engine oil
before you start the engine.
H
Environmental note
When topping up the oil, take care not to spill
any. If oil enters the soil or waterways, it is
harmful to the environment.
! Do not add too much oil. Topping up with too
much engine oil can result in damage to the
engine or to the catalytic converter. Have
excess engine oil siphoned off.
! Do not use any additives with the engine oil.
This could damage the engine.
Example: engine oil filler neck
Observe the information regarding approved
motor oil under "Service products and capaci-
ties" (
Y
page 383).
X Open the bonnet (
Y
page 323).
X
Unscrew and remove cap
:
.
X
Top up the engine oil.
X
Fit cap
:
on the filler neck and tighten.
When doing so, make sure that the cap
engages correctly.
X
Check the oil level with the oil dipstick
(
Y
page 327) or (for vehicles with engine out-
put less than 100 kW) electronically with the
on-board computer:
R
on vehicles without steering wheel buttons
(
Y
page 325)
R
on vehicles with steering wheel buttons
(
Y
page 326)
X
Close the bonnet.
328
Engine compartment
Maintenance and care