Mercedes-Benz Vito 109 CDI/BlueTEC, Руководство по эксплуатации

Страница: 373 / 396

Jacking points
:
(rubber stoppers) are located
just behind the front wheel arches and just in
front of the rear wheel arches.
X
Place jack
;
beneath corresponding jacking
points
:
.
X
Turn handwheel
=
until the plate of jack
;
sits securely on jacking point
:
.
X
Make sure the base of jack
;
is positioned
vertically beneath jacking point
:
.
X Assemble adapter
?
and ratchet
A
from the
vehicle tool kit.
X Place adapter
?
and ratchet
A
on the hex-
agon nut of jack
;
so that the lettering AUF/
UP is visible.
X Turn ratchet
A
in the
AUF/UP direction until
the tyre is raised a maximum of 3 cm off the
ground.
When doing so, jack
;
may move to one of
the side support surfaces.
Removing a wheel
! Do not place wheel bolts in sand or dirt. The
threads of the wheel bolts and wheel hubs
could otherwise be damaged when the bolts
are tightened.
X
Unscrew the wheel bolts.
X
Remove the wheel.
Fitting a new wheel
G
WARNING
Oiled or greased wheel bolts or damaged
wheel bolts/hub threads can cause the wheel
bolts to come loose. As a result, you could
lose a wheel while driving. There is a risk of
accident.
Never oil or grease wheel bolts. In the event of
damage to the threads, contact a qualified
specialist workshop immediately. Have the
damaged wheel bolts or hub threads
replaced/renewed. Do not continue driving.
G
WARNING
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip
over. There is a risk of injury.
Only tighten the wheel bolts or wheel nuts
when the vehicle is on the ground.
Always observe the instructions and safety
notes on "Changing a wheel" (
Y
page 369).
Only use wheel bolts that have been designed
for the wheel and the vehicle. For safety rea-
sons, Mercedes-Benz recommends that you
only use wheel bolts which have been approved
for Mercedes-Benz vehicles and the respective
wheel.
!
On vehicles fitted with a tyre pressure mon-
itor, electronic components are located in the
wheel.
Tyre-fitting tools should not be applied in the
area of the valve, as this could damage the
electronic components.
Only have tyres changed at a qualified spe-
cialist workshop.
Changing a wheel
371
Wheels and tyres
Z