Matrix NAVAN CNX200, Системное руководство

Страница: 409 / 1388

Matrix NAVAN CNX200 System Manual 399
3.
Enter the Location Name for the phone to identify the phone. Location name may be the place where the
phone is located (e.g.: Head office, branch, residence). The Location Name may consist of 18 characters
(maximum). Default: Blank.
4.
Select MATRIX SPARSH VP330 as the Device Type at this location.
5.
Enter the MAC Address
59
of the SPARSH VP330 connected at this location in hexadecimal format:
00:50:C2:55:B0:10. Default: blank.
NAVAN validates the SPARSH VP330 on the basis of the MAC Address, and provides configuration on
validation.
As NAVAN allows registration of the SIP Extension from three different locations, it identifies the SIP
Extension in each location by the programmed MAC address.
6.
Select the appropriate Registrar Server Address to register the SPARSH VP330 with the SIP Registrar of
NAVAN, according to your installation scenario:
• If the Extended IP Phone is connected on the WAN network, select Use Active WAN (Ethernet WAN/
WWAN) as the Registrar Server Address.
• If the Extended IP Phone is connected on the LAN network, select Use Ethernet LAN as the Registrar
Server Address.
• If the Extended IP Phone is connected to the Public Network and NAVAN is located behind a Router,
select
Use Router/STUN's IP Address as the Registrar Server Address.
Make sure the Router’s Public IP Address is configured in the VoIP Port page. You can reach this page
by clicking the PBX Settings tab and then clicking the VoIP Configuration link (on the left navigation
bar).
• If the Extended IP Phone is connected in the Public Network and NAVAN is located behind a NAT
Router, and STUN is programmed, select
Use Router/STUN's IP Address as the Registrar Server
Address.
Make sure the Simple Traversal of UDPs over NAT (STUN) is configured in the VoIP Port page. You
can reach this page by clicking the PBX Settings tab and then clicking the VoIP Configuration link (on
the left navigation bar).
• If Dynamic DNS is configured in the WAN, select Use Dynamic DNS Host Name as the Registrar
Server Address.
7.
To set the call progress tone generation standards of the country where the Extended IP Phone is
installed, select the
Call Progress Tone - Region . Default: Region 1.
See “Call Progress Tones” to know more.
8.
Select the region/country whose Date and Time settings the IP Phone should follow in Date and Time -
Region . Default: India.
59. MAC address is the address of the electronic hardware devices such as a computer, which is hard-coded into the device during
manufacture and cannot be modified. No two devices can have similar MAC address and thus it uniquely identifies your phone.
MAC address is assigned as per the IANA standard. The MAC Address of the phone will be used as source MAC address on all
Ethernet frames.