Matrix NAVAN CNX200, Системное руководство

Страница: 388 / 1388

378 Matrix NAVAN CNX200 System Manual
15.
To assign the Ring Destination for the IP phone, select the desired destination for Play Ring on . You may
choose,
• Speakerphone: The ring will be played on the Speakerphone.
• Headset: The ring will be played on the Headset.
Default: Speakerphone.
When you select the Headset as the destination, make sure that you set the flag ‘ Headset Connected?’ to
Yes and have connected a Headset to the IP Phone.
16.
Select the desired Ring Tune according to your/IP phone user’s preference. Default: 1.
17.
Set the Ringer Volume to the desired level, from 0 to 7, according to your preference. Default: 4.
18.
To increase/decrease the volume of outgoing speech (Transmit Gain) on the handset of the IP phone, set
the
Handset Transmit Volume Level to the desired level, from 0 to 7. Default: 4.
19.
To increase/decrease the volume of incoming speech (Receive Gain) on the handset of the IP phone, set
the
Handset Receive Volume Level to the desired level, from 0 to 7. Default: 4.
20.
To increase/decrease the volume of outgoing speech (Transmit Gain) on the headset of the IP phone, set
the
Headset Transmit Volume Level to the desired level, from 0 to 7. Default: 4.
21.
To increase/decrease the volume of incoming speech (Receive Gain) on the headset of the IP phone, set
the
Headset Receive Volume Level to the desired level, from 0 to 7. Default: 4.
22.
To change the Transmit Gain of the Speakerphone MIC Volume, set Speaker Transmit Volume Level to
the desired level, from 0 to 7. Default: 4.
23.
To change the Receive Gain of the Speakerphone MIC Volume, set Speaker Receive Volume Level to
the desired level, from 0 to 7. Default: 4.
24.
To use a Headset with the IP phone, set Headset Connected? to Yes. Default: No.
Make sure that you connect a Headset to the IP phone, if you select Yes.
25.
Select the Auto Answer check box to enable this feature on the IP phone. Default: Disabled.
When you set the “Auto Answer” feature on the IP phone, the phone goes OFF-Hook automatically after a
preset period of time, without the extension user having to pick up the handset or press the speaker or
headset key. When you enable Auto Answer, you must configure the Auto Answer Timer.
26.
If you enabled Auto Answer on the phone, set the Auto Answer Timer (sec) to the desired value.
This timer defines the time in seconds that the IP phone should wait before going OFF-Hook to auto
answer a call. The range of this timer is 1 to 9 seconds. Default: 1 second.
27.
Set the Back Light Off Time (sec) to the desired value, if required, from 000 to 999 seconds. Default: 10
seconds.
28.
Adjust the Backlight brightness of the phone’s LCD display, by setting the LCD Backlight Level to the
desired value, from 1 to 4. Default: 3.