M.J. MALLIS GROUP SIAT SM 11-SP, Инструкция по эксплуатации и список запасных частей

Страница: 85 / 183

85
Rev. 0
SM11-SP / XL33-SP
SMB00043K
12.9 TROUBLE SHOOTING
SITUAZIONE CAUSA RIMEDIO
When pressing the ON button, the
machine does not start.
The lockable emergency stop button is
pressed.
Short circuit in the electrical system.
Release the emergency stop button.
Check the electrical system.
The magnetothermic protection
opens the main switch.
Motor under stress.
Thermal cut-out not at correct amperage
setting.
Check that the drive belts are not blocked.
Set the correct amperage.
Drive belts do not convey boxes. Narrow boxes.
Worn drive belts.
Top taping head does not apply enough
pressure.
Taping head applying spring holder missing.
Taping head applying spring set too high
Check machine specifications. Boxes are narrower
than recommended, causing slippage and
premature belt wear.
Replace drive belts.
Adjust the box height adjustment with the crank.
Replace spring holder.
Reduce spring pressure.
Drive belts do not turn. Worn or missing friction rings.
Drive belt tension too low.
Electrical disconnect.
Circuit breaker not at correct setting.
Motor not turning.
Replace friction rings.
Adjust belt tension.
Check power and electrical plug.
Set to correct current value.
Evaluate problem and correct
Drive belts break. Worn belt. Replace belt.
Squeaking noise as boxes pass
through machine.
Dry compression rollers.
Defective column bearings
Lubricate compression rollers.
Replace column bearings.
Tape not centered on box seam. Tape drum not centered.
Centering guides not centered.
Box flaps not of equal length.
Reposition tape drum.
Adjust centering guides.
Check box specifications.
Flap kicker kicks at wrong time. Kicker cam improperly set Reposition kicker cam.
The tape leg on the front of the
case is too long.
The tape is threaded incorrectly.
The tape tension is too low.
The knurled roller drags.
Tape tracks to one side or drags on the
support tabs of applying frame.
The one-way tension roller is not
correctly positioned.
Taping heads is not set up properly.
The tape must go around the wrap roller
before going around the one-way tension
roller.
Adjust the one-way tension roller.
Check for adhesive build-up between
the knurled roller and its shaft. Clean and
lubricate shaft.
Remove all lubricate from roller surfaces.
Adjust the tape web alignment.
Position the roller in its mounting slot so that
the tape extends just beyond the center line
of the applying roller.
Check leg length adjustments.