Detailed operation by function groups
173
O
p
er
ati
o
n
D
etai
ls
No
Fault trips
Keypad display
PAR_07 Control Mode
Speed(IM)
V/F
Slip Comp Speed (PM)
29
Battery
Run
Enable battery operation
O
O
O
O
Performing multistep speed (H, M, L) operations
When you set multifunction input terminals P1–P7 to “Speed-L”, “Speed-M”, or
“Speed-H,” the combination of the terminal inputs is used as the speed reference
to run the commands (multispeed 0–7) that are defined at codes FUN_12
through FUN_19.
When multifunction input terminal P1, P2, and P3 are set to Speed-L, Speed-M,
and Speed-H respectively, the following operation becomes available.
Code
Keypad display
Name
Range
Unit
Parameter setting
DIO _01 P1 define
Define multifunction Input
terminal P1 input
-
-
Speed-L
DIO _02 P2 define
Define multifunction input
terminal P2 input
-
-
Speed-M
DIO _03 P3 define
Define multifunction input
terminal P3 input
-
-
Speed-H
The following table lists the multistep speed by the combination of terminals P1,
P2, and P3. If multispeed 0 is selected (terminals P1, P2, P3 are OFF), one of
the three sources is used as the speed reference: Digital input set by the keypad
(FUN_12: Speed 0), analog input at the terminal block, or network
communication signal.
P1
P2
P3
Speed
OFF
OFF
OFF
Speed reference source set at FUN_02
ON
OFF
OFF
FUN_13 (Speed 1)
OFF
ON
OFF
FUN_14 (Speed 2)
ON
ON
OFF
FUN_15 (Speed 3)
Содержание LSLV-L100 Series
