Specifications
Page 95 of 106
Excessive tilting of printer
Your printer is meant to be installed on a flat, level surface. Should the surface on which the
printer is sitting not be level, the following Alert window will appear on your PC when you
attempt to print:
The
Tilt error
message will also appear on your printer’s LCD screen.
You must clear this error before you can do any more printing.
To clear this error, re-locate your printer onto a firm, level surface and wait for the recovery
operations to take place automatically. Once the printer has recovered, the warning messages
will disappear, and your print job will be carried out.
Test page does not print
This applies specifically to networked printers.
If you have set up your Lomond printer using a specific IP address (see
Installing a network
driver
on page 36), and your Test page does not print, the most likely cause is an incorrect IP
address during installation.
Uninstall the printer (see
Uninstalling older printer drivers
on page 49), and then re-install it
using the correct IP address.
Check that your Test Page prints correctly.
Installing older software
Installing an earlier version of the Lomond printer driver on your PC is not recommended. If you
need to install an older version of the Lomond printer driver, contact support personnel.
You will be prevented from installing an earlier version of the Lomond printer driver
software. If you attempt to do so, the following dialog box will be displayed.
Clicking on
Finish
will return you to the initial installation dialog box.
