Setting up your Lomond printer
Page 22 of 106
4.
Prepare a stack of up to 250 sheets of paper (all of the same size) for insertion into Tray 1
as follows:
•
Flex the sheets back and forth to loosen them, then fan them a few times (do not
crease the paper).
•
Remove any obvious loose paper dust from the surface or edges of the paper.
•
Align the edges of the sheets on a level surface.
5.
Load the paper stack into the Tray 1,
with the recommended print side facing down
.
6.
Ensure the maximum number of sheets in Tray 1 does not reach any higher than the
indicator line as shown below.
Figure 2 Tray 1 loaded to its maximum capacity
7.
Grip the top of the Paper Length guide with thumb and forefinger and squeeze the two
tabs together to unlock it.
8.
Slide the guide until it rests gently against the edge of the paper stack, ensuring that it is
aligned with the A4 or Letter mark on the label on the bottom of Tray 1 (depending on the
length of the paper you are loading).
9.
Gently push the Paper Width guide in until it pushes the paper stack against the opposite
side of Tray 1.
10.
Re-insert Tray 1 into the printer until the face is flush with the body of the printer.
