Lenovo NeXtScale nx360 M4, Инструкция по установке и обслуживанию

Страница: 155 / 738

2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove it (see “Removing a
compute node from a chassis” on page 92 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To install the hard disk drive backplate, complete the following steps.
2.5-inch Hard disk
drive backplate
Figure 63. Installing backplate for 2.5-inch
1.8-inch solid state
drive backplate
Figure 64. Installing backplate for 1.8-inch
Step 1. Remove the cover (see “Removing the compute node cover” on page 105).
Step 2. Align the backplate with the hard disk drive cage and the connector on the system board and press
the backplate into position until it is fully seated in the connector.
Step 3. Close the release latch.
Chapter 5
.
Removing and replacing components
141