Lenovo NeXtScale nx360 M4, Инструкция по установке и обслуживанию

Страница: 131 / 738

000
000
000
000
Handle
Screw
Figure 36. Installation of the front handle
Step 1. Orient the front handle so that the blue release latch is toward the middle of the compute node.
Step 2. Align the hole in the handle with the hole on the compute node where the handle is installed.
Step 3. Using a Phillips screwdriver, install the Phillips #2 screw that secures the handle. Install the screw
that you removed when you removed the handle.
After you install the front handle, install the compute node into the chassis (see “Installing a compute
node in a chassis” on page 93 for instructions).
Removing the hard disk drive cage
Use this information to remove the hard disk drive cage.
Before you remove the hard disk drive cage, complete the following steps:
1. Read “Safety” on page v and “Installation guidelines” on page 89.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove it (see “Removing a
compute node from a chassis” on page 92 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To remove the hard disk drive cage, complete the following steps.
Chapter 5
.
Removing and replacing components
117