Lenovo NeXtScale nx360 M4, Инструкция по установке и обслуживанию

Страница: 135 / 738

0
0
0
0
0
0
0
0
0000
0000
0000
0000
0000
0000
0000
0000
0000
0000
0000
0000
0
0
0
0
Screws
Pin
Pin hole
1.8-inch solid-state
drive cage
T8 torx screwdriver
Figure 42. Installing a hard disk drive cage (1.8-inch)
Step 1. Remove the cover (see “Removing the compute node cover” on page 105).
Step 2. Position the cage in the bezel at an angle and rotate the cage into position on the system board.
Step 3. Align the cage with the screw holes on the system board.
Step 4. Using a Phillips (for 3.5-inch hard disk drive cage) T8 torx (for 2.5-inch or 1.8-inch hard disk drive
cage, provided on the back of the chassis) screwdriver, insert the screws (four for 2.5-inch hard disk
drive cage and three for 1.8-inch hard disk drive cage) and secure the cage in the compute node.
Step 5. Install the hard disk drive backplate (see “Installing the hard disk drive backplate” on page 140).
Step 6. Insert the easy-swap hard disk drives and hard disk drive bay fillers (see “Removing and installing
drives” on page 142).
After you install the hard disk drive cage, complete the following steps:
1. Install the cover onto the compute node (see “Installing the compute node cover” on page 107 for
instructions).
2. Install the compute node into the chassis (see “Installing a compute node in a chassis” on page 93
for instructions).
Removing and replacing Tier 1 CRUs
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at your request, you will
be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing the operator information panel
Use this information to remove the operator information panel.
Chapter 5
.
Removing and replacing components
121