Lenovo BladeCenter HS23 1929, Руководство по диагностике и обслуживанию

Страница: 121 / 299

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 3 “ Parts listing ” on page 29 to determine which components are consumable, structural, or CRU
parts.
• If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
Diagnostic
code
Message Description
Action
I.3868000
[I.3868000] BOFM:
System reset performed
to reset adapters. BOFM: System reset
performed to reset
adapters.
No action; information only.
W.3868001 [W.3868001] BOFM:
Reset loop avoided -
Multiple resets not
allowed. BOFM: Reset loop
avoided - Multiple resets
not allowed.
1. Check the IBM support website for an
applicable retain tip or firmware update
(including adapters) that applies to this
memory error.
2. Contact your IBM service representative for
support.
W.3868002 [W.3868002] BOFM:
Error communicating
with the IMM - BOFM
may not be deployed
correctly. BOFM: Error
communicating with the
IMM - BOFM may not
be deployed correctly.
1. Check the IBM support website for an
applicable retain tip or firmware update
(including adapters) that applies to this
memory error.
2. Contact your IBM service representative for
support.
I.3868003 [I.3868003] BOFM:
Configuration too large
for compatibility mode. BOFM: Configuration
too large for
compatibility mode. No action; information only.
W.3938002 [W.3938002] A boot
configuration error has
been detected. Boot Configuration
Error.
1. Run the Setup utility (see “Using the Setup
utility” on page 11), select Load Default
Settings , and save the settings.
2. Recover the server firmware (see
“Recovering from a UEFI update failure” on
page 254).
IMM error messages
Use this information to resolve IMM error messages.
The following table lists IMM error messages and suggested actions to correct the detected problems.
Deassertive events not listed in this table are informational only.
Notes:
• Error Code = IMM events displayed by AMM (for example, Service Advisor, AMM web interface)
• Event ID = IMM events displayed by DSA diagnostic program (for example, in the Chassis Event Log
section)
Chapter 5
.
Diagnostics
105