Konica Minolta IC-304 Plus, Руководство по обслуживанию, Страница: 93 / 148

77
3.3.4 Board Diagnostics
This section describes the diagnostics for the IC-304 print controller boards.
The board included in this category is FusionIN.
Use the JOIND diagnostic utility to test the IC-304 print controller boards. If a board
fails a test, first verify that it is properly connected (turn off the IC-304 print
controller and check the board connections including cables and pins; sometimes
boards may become loose in the PCI slot).
FusionIN Board
Testing Input/Output Memory Modules
Tests the input and output memories on the FusionIN board.
Testing the Fusion
IN
Board
Tests the internal electrical mechanism of the FusionIN board.
3.3.5 Performing a Diagnostic Test
1. Access the JOIND software. See Activating the Diagnostics Software on page 73.
2. Select the components for testing from the diagnostics tree, or select DFE to
test the entire tree, or select Load Quick Batch from the File Menu. See File
Menu on page 74.
3. Click the Loop button to run the tests in loop mode.
4. Click the Run button to activate the diagnostics testing.
5. The system performs the tests and the results appear in the area of the
diagnostics tree: Pass or Fail.
6. If there are components that fail, click the Errors button to view all failed
components or click the Quick Error button to view a specific selected test. See
the
IC-304 Print Controller User Guide
.
Important: Replace a board or a system component that continues to fail its
diagnostics test.
Note: Exit the IC-304 print controller software prior to running the diagnostics
program.
Important: Prior to activating the diagnostics software, verify that the drivers
were loaded successfully (with no error messages during driver loading).