Konica Minolta IC-304 Plus, Руководство по обслуживанию, Страница: 117 / 148

101
4.5.3 Removing and Installing System Board Memory Modules
Your IC-304 print controller comes withDual In-line Memory Modules (DIMMs)
that are installed on the system board in DIMM bank #1A (blue) and DIMM bank
#2A (blue).
Figure 9: DIMM module locations
Preparing to Remove a DIMM
1. Review Safety Information (Multi-Language) on page ix.
2. Turn off the IC-304 print controller and all peripheral devices. Disconnect all
external cables and power cords.
3. Remove the side cover. See Removing the Side Cover on page 93.
4. Verify which DIMM you want to remove. See Figure 10 on page 102.
Removing a DIMM
1. Press down on the two DIMM release tabs so that they rotate outward,
releasing the memory from its seat.
2. Gently pull the DIMM up and out of the server.
Note: Removing or installing DIMMs may change the configuration
information in the server. Therefore, after removing or installing a DIMM, save
the new configuration information by using the BIOS setup utility program.
When you restart the server, the system displays a message indicating that the
memory configuration has changed.
Attention: When you handle electrostatic discharge (ESD) sensitive devices,
take precautions to avoid damage from static electricity.
Attention: To avoid breaking the release tabs or damaging the DIMM
connectors, handle the clips gently.