Konica Minolta IC-304 Plus, Руководство по обслуживанию, Страница: 123 / 148

107
6. While supporting the bracket with one hand, turn over the system board and
place it on the worktable.
7. Return the CPU. See Removing and Installing the Central Processing Unit (CPU) on
page 109.
8. Connect the CPU fan cable to the CPU Fan 6 connector. See Figure 11 on
page 103.
9. Insert the system board into the chassis, and carefully slip it under the five RFI
clips.
Figure 16: RFI-clip positions, internal view
Figure 17: RFI-clip positions, external view
10. Align the system board with the matching hole in each standoff insulator in the
chassis.
11. Insert the nine screws into the holes. Do not tighten the screws until all the
screws are inserted.
12. Return the rear fan. See Installing the Rear Fan on page 124.
13. Return the memory modules. See Installing Memory Modules on page 99.
14. Return the FusionIN board. See Installing the FusionIN Board on page 100.
Note: If you are reusing a metal bracket that was attached to a
previous system board, the glue may have weakened and lost some of
its adhesiveness. Therefore, make sure to support the bracket with one
hand when installing the system board to its upright position,
Attention: Do not bend or damage the RFI clips. Make sure that the five RFI
clips make firm contact with the external-port connectors. See Figure 17.
System Board