Konica Minolta IC-304 Plus, Руководство по обслуживанию, Страница: 58 / 148

42 Chapter 2—Reinstalling the IC-304 Print Controller Software
2.4.3 Disk Striping
After the IC-304 print controller restarts, the
Wrong Disk Configuration
message may appear. This message indicates that the disks need to be striped.
Establishing the Correct Disk Striping Procedure
The
Wrong Disk Configuration
message appears when:
•
The operating system does not identify a disk because a cable, such as a SATA2
or power cable, is faulty or not connected properly. See
Troubleshooting on
page 78.
•
The operating system and the IC-304 print controller software have been
installed from scratch, and the operating system only sees foreign disks. See
Striping Foreign Disks on page 44.
•
An image disk either has been replaced with a new disk or low-level formatted,
and the operating system identifies it as an unknown disk. See
Striping Unknown
Disks on page 45.
•
A faulty image disk has been replace with a new disk, and the operating system
remembers that the disk that was replaced is missing. See
Removing a Missing
Disk on page 48.
Note: If the
Image Disks File System is not Formatted
message
appears, proceed to step 2 of the Confirming the Disk Striping procedure on
page 53.