Konica Minolta IC-304 Plus, Руководство по обслуживанию, Страница: 114 / 148

98 Chapter 4—Hardware and Maintenance Repairs
4.5.2 Removing and Installing the FusionIN Board and Memory Modules
The FusionIN board simultaneously decompresses and RIPs data for the duration of
a job. Perform the following procedures to remove and install the FusionIN board
and memory modules.
Figure 6: Boards and memory modules layout
Removing the FusionIN Board
1. Review Safety Information (Multi-Language) on page ix.
2. Turn off the IC-304 print controller and all peripheral devices. Disconnect all
external cables and power cords.
3. Remove the side cover. See Removing and Replacing the Side Cover and Front
Panel on page 93.
4. Using a cross-head screwdriver, remove the hex screw that holds the board at
the rear of the server.
5. Grip the front left and right corners of the board between the thumb and
forefingers of each hand. Gently lift the board upward.
Note: The two memory modules on the FusionIN board are identical. One
module is for IN_MEM and the other module is for OUT_MEM. See Figure 7 on
page 99.
FusionIN board
CAUTION: Before opening the unit, ensure that the power is turned OFF and
that the unit is disconnected from the AC power socket.