38
© ⅯⅯⅩⅢ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 130115001
SuperLite
®
27
®
The sealed pull pins must be properly rotated into
the locking position prior to diving.
Now, the neck dam/ring assembly is resting directly
under the hat on the diver’s shoulders. The diver
inserts the tongue on the neck dam/ring assembly
into the swing tongue catch on the bottom front of
the helmet.
Grasp the base of the helmet with your fingers and
Push the neck dam/ring up into the neck ring on the
base of the helmet .
The locking collar must fully engage the ring on the
base of the helmet
push the neck dam/ring up into the neck ring on the
base of the helmet. The neck dam ring fits very snugly
in the neck ring. The diver then tilts his head and
the helmet forward and swings the locking collar up
over his shoulders.
The sealed pull pins must be in the locking position.
If they are in the open position, rotate until they snap
into the locking position. Grab the neck ring on the
helmet with your fingers on the outside of the ring
and using your thumbs, push the locking collar/neck
pad assembly up into position until it locks with the
sealed pull pins.
If you have not positioned the sealed pull pins into the
locking position you may do it now with the locking
collar/neck pad assembly in place.
3.8.6 Testing the breathing System
Test the defogger system by turning on and off the de
-
fogger control knob. The regulator should be adjusted
by turning the adjustment knob out until a slight
steady flow starts, then back in until the flow just
stops. Next, the demand regulator system is checked
for proper function: breathe in and out. Inhalation
both sealed pull pins must properly click
into position on the base of the helmet.
If the pins are not engaged correctly the
neck dam/ring assembly may not seal and
the helmet could flood. The diver could
drown as a result.
WARNING
