KEPCO KLP 10-150-2, Руководство пользователя

Страница: 68 / 92

3-28
KLP070312
• The CONFIGURE LAN password restricts the ability to change the LAN configuration
parameters shown on the CONFIGURE LAN page (Figure 3-7.)
FIGURE 3-7. WEB INTERFACE CONFIGURE LAN PAGE
The factory default is that passwords are not needed to access password-protected areas and
none of the three passwords have been established. To set a password for the first time, leave
the CURRENT field blank, enter the new password in the NEW and REPEAT fields, then click
SUBMIT. Subsequent changes require the current password to be entered in the CURRENT
field. If a password is lost or forgotten, the factory default state (no password required) can be
restored from the front panel using the LAN Reset function (see PAR. 3.2.14).
To change a parameter, enter the correct data and/or click the appropriate checkboxes, then
click SUBMIT. If the data is not entered within 20 seconds after the last keystroke, the data will
revert to the previous value. If the LAN CONFIGURATION password was set, you will be
prompted to enter the password before the changes are accepted.
When SUBMIT is clicked after new IP address information is entered, the front panel LAN indi-
cator blinks rapidly while the unit validates the IP address. If the address is valid, the browser
returns to the INSTRUMENT DESCRIPTION page. If the address entered is already in use, the
following note appears towards the top of the page:
NOTE: IP Address is in use.
Click CONFIGURE LAN and choose another IP to correct.
An IP address that is not already in use must be entered and submitted, otherwise the browser
will lock, requiring the browser to be closed and reopened.
Once the configuration has been altered by changing the applicable fields, click SUBMIT to
save the new configuration, or NO CHANGE to clear and reload the page without saving.