KEPCO KLP 10-150-2, Руководство пользователя

Страница: 50 / 92

3-10
KLP070312
4. Rotate the CURRENT control to change the GPIB address, then tap the DC OUTPUT switch
to accept the displayed GPIB address. The display briefly reads
DONE
, then returns to
ADDR
.
5. Rotate the VOLTAGE control until display reads
EXIT
, then tap the DC OUTPUT switch to
exit
3.2.12 CHANGING RS 232 BAUD RATE [STANDARD MODELS ONLY]
The factory default RS 232 baud rate is 38400. To change the baud rate from the front panel
proceed as follows:
1. If the status display shows
SET
, tap either the CURRENT or VOLTAGE controls to take the
unit out of setpoint mode (status display goes from
SET
to blank)
2. Using a thin tool (e.g., a paper clip), press the FUNCTION switch once, then rotate either the
CURRENT or VOLTAGE control until the display reads
BAUD
; the active baud rate 1000 x
the value visible in the DC AMPERES display (e.g., 38400 is displayed as 38.4). To change
the baud rate, proceed to step 3.
3. Tap the DC OUTPUT switch. The baud rate visible in the DC AMPERES display begins
blinking.
4. Rotate the CURRENT control to change the baud rate, then tap the DC OUTPUT switch to
accept the displayed baud rate. The display briefly reads
DONE
, then returns to
BAUD
.
5. Rotate the VOLTAGE control until display reads
EXIT
, then tap the DC OUTPUT switch to
exit
3.2.13 SETTING UP MASTER/SLAVE CONFIGURATIONS [STANDARD MODELS ONLY]
Both units of a master/slave pair must be identical models. After connecting the RS 232 ports
(see PAR. 2.7.8), proceed as follows to configure the individual units. First configure the slave
(see PAR 3.2.13.1), then the master (see PAR 3.2.13.2).
3.2.13.1 CONFIGURE POWER SUPPLY AS SLAVE [STANDARD MODELS ONLY]
1. Turn power on. If the unit comes up in setpoint mode (see PAR. 3.2.6), tap either the CUR-
RENT or VOLTAGE control to take the unit out of setpoint mode (status display goes from
SET
to blank).
2. Using a thin tool (e.g., a paper clip), press the FUNCTION switch once, then rotate either the
CURRENT or VOLTAGE control until the display reads
M/S
.
3. Tap the DC OUTPUT switch.
• The status display reads either
SERI
(series) or
PARA
(parallel).
• The DC VOLTS display shows the number assigned to the unit (1 = master, 2 or above =
slave).
• The DC AMPERES display shows the maximum number of units in the configuration.
• The factory default is standalone operation ( DC VOLTS and DC AMPERES show 1 ).