KEPCO KLP 10-150-1.2K, Руководство пользователя

Страница: 67 / 84

KLP031308
3-27
3.3.6.5.4 RESETTING THE UNIT (*RST) [-1.2K MODELS ONLY]
Click *RST button to reset power supply to the power on default state: setpoints to zero Volts
and minimum Amperes (see NOTE, PAR. 3.2.1, step 3, and Table 1-2), and output set to OFF,
except that if last setting recall (PAR. 3.2.7.3) is enabled, the Setpoint values are from the last
setting.
*RST also clears all LIST entries.
FIGURE 3-10. RESET DIALOG BOX
3.3.6.5.5 USING A LIST (USER-PROGRAMMED SEQUENCES) [-1.2K MODELS ONLY]
Using the LIST feature, up to 100 locations are available for programming the KLP output.
These locations enable the user to program the output using sequential steps which may be ini-
tiated by a single command. The repeatable user-determined sequences are stored in volatile
memory and are retained until reprogrammed, the power supply is turned off, a calibration is
performed, or a
LIST:CLEar
command is received. If a virtual model setting is changed, and a
programmed value is outside the range established by the new virtual model, that step is exe-
cuted as the default minimum (zero V, minimum A) although the location contents are not
changed.
Create the List. Click LIST to open the List dialog box (Figure 3-11). Each location defines the
values for one step: voltage and current, and a dwell time duration (between 0.5 and 655.36
seconds); dwell times down to 0.01 second can be obtained using SCPI commands to generate
the list). (Note the state of the internal relay can be stored using the VXI
plug&play driver or
SCPI LIST commands, but can not be controlled from the web interface). Click Add to List but-
ton to add a step (the information in the Voltage, Current and Dwell boxes) to the List steps
shown to the right.
FIGURE 3-11. LIST DIALOG BOX