KEPCO KLP 10-150-1.2K, Руководство пользователя

Страница: 55 / 84

KLP031308
3-15
NOTE: If a SYSTem:SECurity:IMMediate command is issued, the above relay control settings
are reset to the factory default:
FLT - NORM
.
3.2.13.4 QUICK BOOT
Enter
UTIL
menu (see PAR. 3.2.13, steps 1 through 3) and rotate either VOLTAGE or CUR-
RENT control until status display reads
QkBT
- Quick Boot. If Quick boot is ON, then the next
time the unit is powered up it will go directly to setpoint mode (status display reads
SET
, see
PAR. 3.2.7) without displaying
MODL
,
VIRT
, and
PROT
settings.
• The DC VOLTS display indicates whether quick boot is
ON
or
OFF
.
1. Tap the DC OUTPUT switch to change the setting. The DC VOLTS display begins to blink.
2. Rotate either VOLTAGE or CURRENT control until the desired quick boot state is displayed,
then tap the DC OUTPUT switch to save the setting; the blinking stops.
3. To exit, rotate either VOLTAGE or CURRENT control until the status display reads
RTN
,
then tap the DC OUTPUT switch. To exit the
UTIL
menu rotate either VOLTAGE or CUR-
RENT control until the status display reads
EXIT
, then tap the DC OUTPUT switch.
3.2.13.5 SYSTEM CONFIGURATION FUNCTIONS
The system configuration functions allow the user to determine 1) whether the Remote Inhibit
signal is an active TTL high or low and 2) how the unit recovers from a fault. The unit password
is required to change these functions.
1. Enter
UTIL
menu (see PAR. 3.2.13, steps 1 through 3) and rotate either VOLTAGE or CUR-
RENT control until status display reads
SYST
.
2. Tap the DC OUTPUT switch to enter the System Configuration Functions menu.
3.2.13.5.1 REMOTE INHIBIT CONFIGURATION
The Remote Inhibit signal REM_INH is applied to analog I/O port, pin 8 (see PAR’s. 2.7.9 and
3.4.1). This signal can be configured to be active (inhibit the output) for either a TTL high or low.
1. Enter
UTIL
menu (see PAR. 3.2.13, steps 1 through 3) and rotate either VOLTAGE or CUR-
RENT control until status display reads
SYST
, then tap DC OUTPUT switch. Rotate either
VOLTAGE or CURRENT control until the status display reads
rINH
and the DC VOLTS dis-
play reads either
Hi
or
Lo
.
2. To change the remote inhibit setting, tap the DC OUTPUT switch. The status display shows
PASS
. Enter the unit password (see PAR. 3.2.5) and tap DC OUTPUT switch to accept the
number. When the password is accepted, the status display reads
rINH
and DC VOLTS dis-
play is blinking.
3. Rotate either VOLTAGE or CURRENT control until DC VOLTS display reads desired set-
ting, then tap DC OUTPUT switch to accept.
4. Tap FUNCTION switch to exit or rotate VOLTAGE or CURRENT control until status display
reads
RTN
, then tap DC OUTPUT switch to return to next highest menu.