9.6.2.15. Configuration - Master/Slave Mode
Multiple AccessPoints can be connected together to one system for the exchange of configuration data (users,
doors, permissions). This compound operation mode is also called „Master/Slave“ mode. Here one of the
AccessPoints if configured as „Master“, all other AccessPoints as „Slaves“.
The „Slaves“ receive the configuration data from the „Master“ AccessPoint. With this operating mode changes of
the configuration have to be made only on one device.
Master/Slave Mode
Determines whether the AccessPoint works as „Master“ or „Slave“. When set to „Slave“, the IP address of the
„Master“ AccessPoint has to be entered.
The address is required for the synchronization. Configuration data is also only accepted from this IP address.
When operating as „Master“, all slaves in the system have to be configured/listed in the „Master“ AccessPoint.
All „Slaves“ are listed with name and IP address.
By pressing „+“ additional slaves can be added, existing profiles can be edited with the pen.
In the profiles a unique name (place of installation) and the IP address for the slaves has to be entered.
9.6.2.16. Configuration - Network cameras
One network camera can be assigned to each Kentix-DoorLock component, to request multiple pictures from
the camera and link these to the corresponding logbook entry. For this purpose any network camera can be
used which is able to deliver pictures via a HTTP command.
Enter a name for the camera (for example the installation place) as well as the camera-specific data (IP
address, user data) and select the camera location.
The field „HTTP Command“ contains an example for an AXIS camera. Enter the path to the image source file
here without specifying the IP address or communication port beginning with a slash.
Camera location
Description
Inside
The camera is installed in the room, which is entered after the door is opened.
The recording begins at the moment of the booking. 10 pictures are saved.
Outside
The camera is installed in front of the room.
3 pictures are pre-bufferd and 7 additional pictures are stored beginning from the moment of the booking.
Page
(07-2018, subject to change)
kentix.com
86
NOTE!
Prerequisite for the "master / slave" operation is the availability of all access points via an existing network.
If necessary, contact the responsible administrator to discuss the requirements for the operation of the
access system.
Please also refer to the point "Communication Ports" earlier in this manual.
NOTE!
The image data are stored on the respective local AccessPoint. In Master-Slave-operation with several
AccessPoints, SD cards must also be used in the slaves depending on the configuration.
The HTTP command for the request of images can be found in the documentation of your network camera.
Note that the image size of 200 kilobytes per image must not be exceeded. This may have to be taken into
account when entering the HTTP command.
Sm
a
rt
A
c
c
e
s
s
