9.6.1.2.
Initial setup - Master card set
No
Step
Note / Signalization
1
Servicekey card (
yellow
) in front of knob to activate
This step is only required once during initial
startup.
1
Present Servicekey card (
yellow
) in front of DoorLock-
devices reading unit.
This step has to be performed only one time at the
initial setup.
At a door lever, wall reader or cabinet lock the initial
setup is completed with this step.
2
Present Servicekey card (
yellow
) again in front of knob
to start programming mode.
3
Present Battery replacement card (
green
) in front of
knob.
4
Present Disassembly card (
blue
) in front of knob.
5
Present Servicekey card (
yellow
) in front of knob to
leave programming mode.
1x short sound, 1x long sound
2x short sound, 1x long sound
then wait for 5 seconds
3x langer Ton
1x short sound, 1x long sound
2x short sound, LEDs light up green
then wait for 5 seconds
2x short sound, LEDs light up green
then wait for 5 seconds
Page
(07-2018, subject to change)
kentix.com
75
NOTE!
For the initial setup of door levers, wall readers or cabinet locks the teaching of battery changing and
dismantling card is not required. The door lever has to be woken up by presenting any RFID card in front of the
reader unit. Then the servicekey card must be held in front of it for one time. After this the process is finished.
As the wall reader is permanently powered a wakeup with a RFID card is not necessary.
At a cabinet lock the wakeup button has to be pressed before holding the Servicekey card in front of the
reader.
If the initial programming leads to an error, a DoorLock-device can be reset using the Servicekey card. Please
read the chapter „Reset of components“ later in this manual.
Sm
a
rt
A
c
c
e
s
s
