8.7. Kentix Alarm siren (KFLASH1)
The Kentix Alarm sirene can be used for an acoustical and optical signalization in case of an alarm.
It is suitable for an indoor and outdoor installation (protection class IP65).
The Alarm sirene is equipped with a 10 meter patch cable and a RJ45-connector and can be directly connected
to the system jacks of an AlarmManager or to all MultiSensor-RF/-LAN/-LAN-RF using an additional adapter
(RJ45-T-Adapter). The required adapters are included with the Alarm sirene.
Connection example: Alarm siren at AlarmManager or MultiSensor
Plug in the Alarm sirene into the RJ45 T-Adapter and connect the MultiSensor to the socket next to it using a
patch cable. The power supply is done via a Power-Adapter (KIO2), which is connected to the opposite side of
the T-Adapter.
When also the alarm input of the connected MultiSensor shall be used (e.g. by connecting a leakage sensor), a
KIO2 Power-Adapter can be used instead of the KIO1. In this case all connection cables have to be patch
cables.
8.7.1. Configuration
To trigger the Alarm sirene relay times have to be configured in the AlarmManager or the MultiSensor.
For the AlarmManager and all MultiSensors operating in AlarmManager mode the relay timings in the settings of
the corresponding alarm zone are also used for the sounder.
Here one time for armed-active alarms and one time for always-active alarms can be defined.
Page
(07-2018, subject to change)
kentix.com
49
Po
w
e
r—Ad
a
p
te
rs
Accessories
AlarmManager / MultiSensor
KENTIX System port
Alarm siren
KIO1 or KIO2
Power-Adapter
RJ45 T-Adapter
T
