JA-101K(-LAN)(-LAN3G) and JA-106K(-3G)
Security System Control Panels
20
/
110
MLJ51410
5 Installation of BUS devices
Connect BUS devices of the JA-1xx Jablotron series to the system. Proceed with the following procedure:
1. During the connection of any BUS modules the power supply of the control panel must be completely off.
2. Follow the installation manuals of individual devices.
3. The BUS cable must be installed inside the area that is protected by the system. If the cable is outside the
protected area, this part must be separated with a JA-110T BUS isolator.
4. For line branching use a JA-110Z BUS splitter (and the JA-110Z-A, JA-110Z-B, JA-110Z-C).
5. During the connection of BUS devices pay attention to the colour of wires (red, yellow, green, black).
Connection of third party devices or a device of a different producer is possible via an appropriate module
such as the JA-111H, JA-116H, JA-110M, JA-118M, JA-114HN, etc. The producer (Jablotron) cannot guarantee
proper functioning of the connected device even not its security grade.
5.1
JA-100 BUS
The BUS of the JABLOTRON 100 system consists of four wires (4-wire). The BUS is only for the
JABLOTRON 100 system and it cannot be shared with another system not even to power different devices. For
powering other systems by BUS (smart home automation) use the JA-121T interface or the JA-110T BUS
isolator.
terminal
colour
note
+U
red
positive power supply terminal;
it can only be used to supply
devices
of
the
JABLOTRON 100 series
A
yellow
data A
B
green
data B
GND
GND
common terminal
(negative
power
supply
terminal)
BUS terminal board
5.2
BUS cables
Resistance of the pair of power supply wires (there and back)
CC-01
resistance of the pair per 1 m
resistance of the pair per 10 m
resistance of the pair per 100 m
CC-02
resistance of the pair per 1 m
resistance of the pair per 10 m
resistance of the pair per 100 m
CC-03
resistance of the pair per 1 m
resistance of the pair per 10 m
resistance of the pair per 100 m
Connect BUS devices using a Jablotron CC-01, CC-02 or CC-03 cable or equivalent.
The Jablotron CC-01 cable
is designed for the main BUS line, or the connection of elements with a high
consumption (siren) or remote elements. The cable has 4 wires (the colours corresponding to the BUS colour).
The power supply wires (black and red) have a bigger cross-section of the core (0.5 mm
2
) as compared to the
communication conductors (0.2 mm²). The cable is supplied in packs (1 pack - 300 m).