J. D. NEUHAUS Profi 025Ti, Руководство по эксплуатации

Страница: 98 / 218

As a hoist operator, you are responsible for your
own safety and that of your colleagues in the
working area of the hoist.
Hoists may only be operated by persons charged
with this task by their company.
Before using the JDN Air Hoist for the first time,
familiarise yourself with all permissible operating
conditions. For this purpose, read through this
operation manual thoroughly and carry out the
described actions on the hoist, step by step.
Report each malfunction to your safety officer
immediately, so that the fault can be remedied
without delay.
Adhere to the regulations of the accident prevention
authorities (e.g. trade association regulations in
Germany).
Read the section Intended use , page 15.
The following situations, among others, are regarded
as improper use:
Changing load-carrying capacity depending on load
position: JDN Air Hoists are not equipped with load-
carrying capacity indicators, they may therefore only
be used in those applications in which the load-
carrying capacity does not change with the position
of the load.
Oblique pulling of loads in general.
Definition of oblique pulling
Oblique pulling is the deviation of the load chain and
the chain hoist from the vertical position, for a force
acting in a straight line between the force’s point of
application of the load on the load hook and the
suspension on the supporting structure.
Under special safety provisions relevant to the particu-
lar situation, JDN Air Hoists may be used for oblique
pulling (see
Intended use , page 15). In this case, a
chain box must not be used, as the chain may fall out
or become knotted. Oblique pulling is not permitted for
hoists installed in trolleys or in running gears. Please
contact us, if required.
Breaking loads free or dragging loads.
Loading of the hook at the tip.
Catching falling loads.
Carrying persons (see Intended use , page 15).
Jog control with load on the hook.
Switching to the opposite direction with the load
in motion.
Reaching lifting and lowering limiters as part of
normal operation.
Never hold the centre section of the chain under
tension when the load hook is in the upper or lower
limit position.
Oblique pulling
R U L E S F O R S A F E
O P E R AT I O N O F H O I S T S
powered by air !
O P E R AT I O N
O P E R AT I O N
Page 30