J. D. NEUHAUS Profi 025Ti, Руководство по эксплуатации

Страница: 24 / 218

C O N N E C T I N G F - CO N T RO L S
Pull the bellows over the hose bundle for F-control.
For F-dual-control (for lifting and lowering only),
remove approximately 50 mm of hose bundle protec-
tive sheathing.
Insert the control hoses into the connection nipples
(see illustration on page 23, bottom):
• Compressed air supply
with hose designation 1 or colour: white
• Movement direction “lift”
hose designation 2 or colour: green
• Movement direction “lower”
hose designation 3 or colour: red
For F-control with additional functions (trolley,
crane movement) remove approx. 50 mm of protective
sheathing and slit open the protective hose a further
50 mm in order to route the control hoses for com-
pressed-air connection, trolley and crane movement
outwards in front of the bellows. (Close off com-
pressed-air connection at the control valve using
screw plug G 1/8). Pull both strain-relief cables
through the eye bolt and secure using rope clamps.
The control hoses for the drive motors (trolley,
crane movement) and for the compressed air supply
must be extended, outside of the bellows, by means
of plug-in connectors and additional control hoses.
Connection see “Trolley” operation manual.
C AU T I O N !
The control hoses must not be subject
to tensile load; adjust the strain-relief
ropes accordingly.
Insert the bellows frame into the profile of the
bellows, insert bellows clamps (long end pointing
inward) and secure to the control valve using bolts
(2 x M5).
C O N N E C T I N G F I - CO N T RO L S
Pull the bellows over the hose bundle for FI-control.
Remove approx. 50 mm of hose bundle protective
sheathing. With this type of control, strain-relief of
the hand controls takes place via the protective
sleeve of the hose bundle. For this purpose, the pro-
tective sleeve is pushed onto the hose carrier and is
secured using a one-ear clamp.
Installation facilitation: Heat the protective sleeve
(hose sheathing) with a hot-air gun and grease the
hose carrier. Slightly bend open the ring of the eye bolt
in order to attach the hose carrier. Close the ring again
to prevent detaching.
Insert the control hoses into the connection nipples
(see illustration on page 23, bottom):
• Compressed air supply
with hose designation 1 or colour: white
• Movement direction “lift”
hose designation 2 or colour: green
• Movement direction “lower”
hose designation 3 or colour: red
(see illustration on page 23, bottom)
C AU T I O N !
The control hoses must not be subject
to tensile load; adjust the length of the
protective sleeve accordingly.
Insert the bellows frame into the profile of the bel-
lows, insert bellows clamps (long end pointing inward)
and secure to the control valve using bolts (2 x M5).
powered by air !
SETTING UP
Page 24